GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: Jack111 on 27 November 2012, 17:32
-
full decat straight pipe, ko3s, fmic ,uprated dv,running 0.5 bar 18bhp on the dyno is that good?
tuner recons its good as the graph was spot on but im not so sure
after map he recons it will do 225-230
-
No way, massively overinflated dyno results :whistle:
The KO3 will max out at around 200bhp so regardless of supporting mods you will not see higher than that.
-
What torque did it make?
-
sorry guys it has a ko3s 175ft pound
-
Hang on, don't really understand the question haha :laugh:
-
It's not exactly standard if its got a k03s on an agu anyone correct me if I am wrong here
-
no its not standard the map is, i blew the old engine up so this is a new one so everything has been put back to standard and i put on the rollers to see what it was doing at standard levels 0.5 bar standard smic straight pipe dump valve , thought it was a bit low but after doin research its normal as aums are 180 with ko3s standard
-
Aum is 150 standard and surely what it is after a map is more important then before so just map it :grin:
-
no its not standard the map is, i blew the old engine up so this is a new one so everything has been put back to standard and i put on the rollers to see what it was doing at standard levels 0.5 bar standard smic straight pipe dump valve , thought it was a bit low but after doin research its normal as aums are 180 with ko3s standard
Without any form of map 180bhp still sounds too high to me :undecided:
AUM is 150bhp standard and maps to around 210bhp, AUQ is 180bhp standard.
-
as i said this is a second engine and dint really know the history apart from 80,000 and had a cambelt in its life
so i wanted to get it on the rollers and check if it was healthy before running stupid power thanks for all comments /just wanted to know if 180 was good for agu with k03s not mapped
-
I hit 174bhp on a standard AGU map with bolt on bits
-
so 180 is good then off i go for custom map thanks
-
The rollers could be over reading or maybe the operator was being generous,
Rolling Roads should only be used as a guide and not taken as gospel,
A rolling road operator could make the rollers read pretty much any figures they want.
-
what engine is it you're put in? AGU or AUM? I do hope it's an agu.....
Still, with those mods, 180bhp seems fairly good going, but not impossible. where was the dyno?
-
yes agu engine and it was as at (southwest in car tech)
-
i had an AGU K03S audi A3 on the dyno a few weeks ago and that did 180bhp with the standard map, similar torque to yours too
-
so is 225-230 possible then after map
-
Yeah 225bhp is acheivable mate aslong as everything is healthy.
Mine ran 195bhp on a ko3 stage 1 map on my AGU.
Bolt on THS front mount, KO3s and few others such forge 007p and actuator it run 210bhp on the rollers before a stage 2 remap.
With everything listed in my sig it ran 232bhp and 270lbs of power :cool: