GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: km on 12 September 2012, 17:51
-
I've ran into another problem :embarrassed:.
As I was fitting the bush, I used a longer bolt to close the gap. As I went to remove it, it became stuck?
It's almost as if there's a nut stuck on the other end, it's loose and keeps spinning but is unable to pull out.
Advice please?
-
Front ARB I asumme...
You used a longer bolt just to wind it down a bit and then went to remove the longer bolt to re fit the original bolt, is that correct?
Umm....Give it a good spray with some WD40 and really pull on it while un screwing it perhaps, try and get something to lever on it to pull on it with! :undecided:
-
Yep correct.
Don't know how I can pull on it as well to be honest but I'll try again in a week or so when I can be bothered.
Just want to know why it's happened too!