GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: tweed on 12 July 2012, 18:43
-
ok my new manifold and decat pipe holes don't line up.
manifold flange hole centers are 74mm
decat flange hole centers are 82.5/83mm
the holes on the manifold are big so I could drill out the decat but not the point.
I would like to know if all mk3 gti 8v's have the same manifold?
I know the cats are different length but don't know why?
I have a short cat on my gti but bought a early gti long decat, I did this so I can cut a section out and weld in a flexi pipe. I don't want to do this now if the hole pcd is different on the cats.
anyone got a genuine cat lying about to measure the hole gap?
any help is much appreciated :smiley:
-
or has anyone got a gasket they could measure for me please
-
My last ADY had the 3 large centre holes and my AGG has 3 smaller pitch, the ADY did have massive CAT on it though :undecided:
Suggest you look up on ETKA and examine the exploded diagrams.
You are talking about the down pipe flange to CAT flange?
-
My last ADY had the 3 large centre holes and my AGG has 3 smaller pitch, the ADY did have massive CAT on it though :undecided:
Suggest you look up on ETKA and examine the exploded diagrams.
You are talking about the down pipe flange to CAT flange?
yes.
I have bought aftermarket. That makes sense. Manifold must be same as agg and the decat is ady. So I could get a short decat and the holes would match the manifold.
I'll check now
-
omg I can't use it :angry:
can you post up a diagram please?
-
Bump.
I remember me and stainsey looking at a while ago but can't find it. We was looking at the length of vr6 cat for his 8v
-
Hmm looks like the ADY/ AGG/2E are the same
http://www.vagcat.com/p/B121/253580.png
2E
http://www.vagcat.com/epc/cat/vw/GO/1992/121/50/1267402/
Hmmmm
-
they won't open for me :angry:
does it give the distance of the 3 holes on the flange?