GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: Big Tone on 26 June 2012, 15:35
-
I have a leak, oil, from the cam chain tensioner gasket. Question is; can I repair this without removing the rocket cover, cams etc?
Or is it a big job? can it be done in-situ? Thought about cracking the three torx bolts on the tensioner but didn't want to do this until I had asked you guys.
Any advice is much appreciated.
-
Is it leaking below the rocker, usually just a rocker off job. No need to touch cams etc. The gasket is a two piece kit, one piece along the outside and a centre piece around where sparks or coil packs sit.
Easy job and done while engine is in, no need to take it out.
-
Is it leaking below the rocker, usually just a rocker off job. No need to touch cams etc. The gasket is a two piece kit, one piece along the outside and a centre piece around where sparks or coil packs sit.
Easy job and done while engine is in, no need to take it out.
Its not the gasket between the rocker cover and the block, its the gasket between the cam chain tensioner and the block, ill try n get a pic.
-
This is a fairly common fault.
There's a special tool to allow you to lift the tensioner up slightly. I bought the tool already but never got round to buying the seals and fixing it.
Here's a good linkie:
http://www.audizine.com/forum/showthread.php/275895-How-to-1-8T-Cam-Chain-Tensioner-Gasket-replacement
;)
-
This is a fairly common fault.
There's a special tool to allow you to lift the tensioner up slightly. I bought the tool already but never got round to buying the seals and fixing it.
Here's a good linkie:
http://www.audizine.com/forum/showthread.php/275895-How-to-1-8T-Cam-Chain-Tensioner-Gasket-replacement
;)
Top man, fridays job!
Think iwill be making a tool though, lol.
-
Done .
Much better plus no horrible rattle in start .
Result.
Ta
-
Done .
Much better plus no horrible rattle in start .
Result.
Ta
Did it cure a startup rattle? Ours does this from cold, for the first split second (sounds awful). Didn't know the tensioner gasket fixed this! I'll be dusting off that tool and getting this done ASAP!
-
Yep. No awful chain rattle anymore.
I used some 6mm stud bar and made up a small bracket. Lol