GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: Aarons golf mk3 on 19 June 2012, 17:59
-
No power going to my injections help
-
Ecu relay 30 ,worth a try .
-
which engine are we talking about? far not all ECU's have a relay 30 ;)
-
Gti engine 2.0 but it did have 1.6 in changed the wiring loom four 2.0 ands my dad saying my fuel pump not work aswell eny one can help me
-
Fuse? Immob?
-
The immob it didn't come with the engine but can I use my one off the 1.6 engine or not if so how can I get around it thank for all your help
-
have to un-wire / bypass it, i.e. get a sparky out or DIY
-
So if it gets bypass would I get power to them en
-
could be, an immob will typically stop power going to the fuel pump relay, and something else, i.e. ignition coil to stop you stealing the car. If you bypass it / remove it you remove that part of the problem.
That said, it might not be the problem, so may not get you any further.
-
What year was the 2.0, later cars have a built in immob which need sorting, no power to the injectors could be down to a wiring problem.
-
It's a r reg car and how would I go about bypass the immob then
-
So you put a 2.0 engine in a 1.6 changed loom so on so on but have you changed the ecu to match the engine as the 1.6 is SPI (single point injection) and the 2.0 is not so this could be a problem as it has more to do...If not you will need
ECU from AGG/ADY Depending on engine code and poss the immo box and chip unless you can recode it with vagcom or a early ECU for a 2.0 which didnt come with immo
Relay 30 or 32
-
Where can I get someone to do vagcom then Bridgend eny one now someone how can do tht for me. to night or ASAP thank