GolfGTIforum.co.uk

General => General discussion => Topic started by: sharki786 on 08 June 2012, 19:54

Title: look like 509T but half the size. pics inside!!
Post by: sharki786 on 08 June 2012, 19:54

Need them for the climate control panel (golf mk3). As the 509t's are huge these are same fitment but smaller & the bulb seems to be further in.

im after the dark green bulb



iv put it next to the LIGHT GREEN & RED 509T so you can see the size of it (these fit the golf mk3 clocks & are 509T).

(http://i323.photobucket.com/albums/nn458/shako786/SL372697.jpg)


the light green is from the speedo:

(http://i323.photobucket.com/albums/nn458/shako786/SL372700.jpg)


(http://i323.photobucket.com/albums/nn458/shako786/SL372702.jpg)

Title: Re: look like 509T but half the size. pics inside!!
Post by: Bandit127 on 08 June 2012, 20:27

No help here yet... Off to the stealers I would... Probably cost you £1.50 a go...

Title: Re: look like 509T but half the size. pics inside!!
Post by: spikenipple on 08 June 2012, 21:11

How easy is it to change the bulbs illuminating the speedo? Both of mine have blown  :undecided:

Title: Re: look like 509T but half the size. pics inside!!
Post by: sharki786 on 08 June 2012, 22:02

Quote from: Bandit127 on 08 June 2012, 20:27

No help here yet... Off to the stealers I would... Probably cost you £1.50 a go...

been to them today and they was cofused as there aint no pn on it.

p.s these are only 1cm in size!!!

Quote from: spikenipple on 08 June 2012, 21:11

How easy is it to change the bulbs illuminating the speedo? Both of mine have blown  :undecided:

not that hard they just twist out. do a search in the mk3 section

Title: Re: look like 509T but half the size. pics inside!!
Post by: thai-wronghorse on 09 June 2012, 00:11

Check your mk3 thread, i think i've found the part number.

Title: Re: look like 509T but half the size. pics inside!!
Post by: danny_p on 09 June 2012, 23:56

looks like it's scrap then  :evil:

Title: Re: look like 509T but half the size. pics inside!!
Post by: gladysp200 on 10 June 2012, 01:31

(http://www.dingsme.info/avatar10.jpg)How easy is it to change the bulbs illuminating the speedo?

Title: Re: look like 509T but half the size. pics inside!!
Post by: sharki786 on 10 June 2012, 02:16

they not that hard to change. they just Twist out. But what people tend to do is solder some 3mm 12v leds. But remeber to take the green filter out and replace with a clear or frosted 1. I replaced it with a frosted 1. To take the green plastic out all you have to do is unclip the white part of the dial of. i then drilled 5 or 6 3mm holes and soldered on the 12v resistors and all was good.  do a search in the mk3 section.