GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: AntMk3GTi on 11 May 2012, 10:58
-
Hi
Does anybody know the internal diameter of the smaller coolant hoses on top of the engine bay near the expansion tank, the ones that lead to and from the expansion tank and towards the back of the engine bay?
Thanks
-
...engine is 1.8t AUM.
-
9mm rings a bell mate.
Pull one off and measure :wink:
-
Ok cheers. I was looking at lengths of silicone in either 3mm, 4mm or 5mm and was going to order 4mm. But if you say 9mm yeh I think i'll double check and measure one.
I thought 4mm cos they look about the same size as the vac hose on the diverter valve.
-
i measured them at 8-9mm
-
Cheers, and this is definitely the internal diameter not outer?
-
9mm rings a bell mate.
Pull one off and measure :wink:
i just pulled one off then measured it, it was 8.5" then it started going floppy :smug:
-
Damnnnn I have a good guess :laugh:
-
9mm rings a bell mate.
Pull one off and measure :wink:
i just pulled one off then measured it, it was 8.5" then it started going floppy :smug:
*shakes head* :grin:
-
9mm rings a bell mate.
Pull one off and measure :wink:
i just pulled one off then measured it, it was 8.5" then it started going floppy :smug:
:grin: I should have seen this coming hahaa