GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: mk3tony on 13 March 2012, 15:23
-
my 3inch miltek catback rests on my rear axle, is this correct? There isn't a lot of room to move it and the worry is that if its moved up a tiny bit using new mounts that it'll knock the axle. At the moment its resting on the axle and obviously bumps etc are slightly twisting the rear section
-
happens on mine aswell :grin: so friggin annoying! i think when i get it back, ill try and heat wrap it so if it knock's it wont be as noticable! or move it much aswell
-
It a tight fit mine was knocking with people in the back Milltek re fitted it for free with new SS clamps its spot on now :smiley:
-
what clamps are you referring to rich? my exhaust was s/h and only came with 1 clamp. its got 2 normal clamps on rear section
-
what clamps are you referring to rich? my exhaust was s/h and only came with 1 clamp. its got 2 normal clamps on rear section
They changed all the clamps for new ones :smiley: They said a common thing is people don't push the system together properly - they say it should never knock even on a lowered car :smiley:
-
hmmm, mine was sitting dead straight but the bend sat on the axle itself nothing could be dine, raising it up would mean the tips were very close to the valance.
-
hmmm, mine was sitting dead straight but the bend sat on the axle itself nothing could be dine, raising it up would mean the tips were very close to the valance.
Give Milltek a ring they are very helpful :wink:
-
hmmm, mine was sitting dead straight but the bend sat on the axle itself nothing could be dine, raising it up would mean the tips were very close to the valance.
Give Milltek a ring they are very helpful :wink:
can you take it to any milltek dealer to get it sorted mines knocking to?
-
hmmm, mine was sitting dead straight but the bend sat on the axle itself nothing could be dine, raising it up would mean the tips were very close to the valance.
Give Milltek a ring they are very helpful :wink:
can you take it to any milltek dealer to get it sorted mines knocking to?
Not sure about that, I took mine to the Milltek factory, give them a ring they will be able to help you sort it.
-
hmmm, mine was sitting dead straight but the bend sat on the axle itself nothing could be dine, raising it up would mean the tips were very close to the valance.
Give Milltek a ring they are very helpful :wink:
can you take it to any milltek dealer to get it sorted mines knocking to?
ok mate ill give em a ring :cool:
Not sure about that, I took mine to the Milltek factory, give them a ring they will be able to help you sort it.
ok mate ill give em a ring :cool:
-
i've just called AMD who are the nearest dealer to me and they will look at it for me for a charge of £30 + vat. Steep but its winding me up! :cry: