GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: mike1990 on 08 March 2012, 19:50
-
Hello everyone i'm new here, i've just bought a 51 plate golf gti 1.8t aum engine
Few problems with it, nothing major.. when starting the car the half height display reads "AIRBAG FAULT" then beeps, then that goes off and it says "SERVICE NOW" i understand the service now, but it's only just been serviced. I don't know what the airbag problem is though.
There is a crack in the passenger side wing mirror, could the mirror just be replaced?
Also, the boot won't open.. i've tried turning the key in the boot and the barrel wont move. The handle doesn't do anything either.
Could anyone shed any light to my problems?
-
Welcome :cool:
See this for the service indicator.
http://www.golfgtiforum.co.uk/index.php?topic=62717.0
Air bag fault could be the plugs under the seats.
The mirror can be replaced which part is broken glass of the cover? You can get bits here http://www.vwspares.co.uk/g4body.php
The lock in the barrel is seized common fault try some WD40 :smiley:
-
Thank you :) it's the mirror, not the case. I'll try the WD40 tomorrow.
-
Also, the ASR button doesn't seem to work, i press it and nothing happens.. the traction control light doesn't come up on system check when i turn the key. I think it could possibly be the fuse but i don't know really.
Any advice or information would be appreciated
-
Also, the ASR button doesn't seem to work, i press it and nothing happens.. the traction control light doesn't come up on system check when i turn the key. I think it could possibly be the fuse but i don't know really.
Any advice or information would be appreciated
You got a fault scanner? Or a version of VAGCOM available to hand? If so run a scan on it and it should give you anything and everything that is wrong...or try and borrow one, there is a 'lend a hand section' and a vagcom map, try contacting a few members perhaps! :smiley:
-
I do yes, although i've got the old usb 16pin obdii lead that i bought for my old polo 16v, i'm not sure if that would still work
-
The ASR might not be working due to the ABS fault, get it scanned for codes as a 1st step.
-
I've now scanned the car for fault codes and i'll copy and paste the log
VAG-COM Version: Release 409.1-S
Chassis Type: 1J - VW G/J/B Mk4
Scan: 01,02,03,08,16,15,17,19,22,35,46,56
-------------------------------------------------------------------------------
Address 01: Engine
Controller: 06A 906 032 HJ
Component: 1.8L R4/5VT 0002
Coding: 11500
Shop #: WSC 00028
WVWZZZ1JZ2P049312 VWZ7Z0A4279546
2 Faults Found:
16486 - Mass Air Flow Sensor (G70): Signal too Low
P0102 - 35-00 - -
18058 - Powertrain Data Bus: Missing Message from Instrument Cluster
P1650 - 35-10 - - - Intermittent
Readiness: 0000 1101
-------------------------------------------------------------------------------
Address 03: ABS Brakes
Controller: 1C0 907 379 K
Component: ASR FRONT MK60 0103
Coding: 0021505
Shop #: WSC 00028
1 Fault Found:
01314 - Engine Control Module
013 - Check DTC Memory
-------------------------------------------------------------------------------
Address 08: Auto HVAC
Controller: 3B2 907 044 C
Component: CLIMATRONIC C 2.0.0
Coding: 11000
Shop #: WSC 00028
No fault code found.
-------------------------------------------------------------------------------
Skipping Address 15-Airbags
-------------------------------------------------------------------------------
Address 17: Instruments
Controller: 1J0 920 926 A
Component: KOMBI+WEGFAHRSP VDO V06
Coding: 05412
Shop #: WSC 00000
WVWZZZ1JZ2P049312 VWZ7Z0A4279546
7 Faults Found:
00779 - Outside Air Temp Sensor (G17)
30-10 - Open or Short to B+ - Intermittent
01128 - Immobilizer Pickup Coil (D2)
35-10 - - - Intermittent
01176 - Key
07-10 - Signal too Low - Intermittent
01314 - Engine Control Module
49-10 - No Communications - Intermittent
01316 - ABS Control Module
49-10 - No Communications - Intermittent
01321 - Control Module for Airbags (J234)
49-10 - No Communications - Intermittent
01336 - Data Bus for Comfort System
49-10 - No Communications - Intermittent
-------------------------------------------------------------------------------
Address 19: CAN Gateway
Controller: 6N0 909 901
Component: Gateway K<->CAN 0001
Coding: 00006
Shop #: WSC 00028
4 Faults Found:
01314 - Engine Control Module
49-10 - No Communications - Intermittent
01316 - ABS Control Module
49-10 - No Communications - Intermittent
01321 - Control Module for Airbags (J234)
49-10 - No Communications - Intermittent
01336 - Data Bus for Comfort System
49-10 - No Communications - Intermittent
-------------------------------------------------------------------------------
Address 46: Central Conv.
Controller: 1C0 959 799 B
Component: 1X Komfortgerát HLO 0003
Coding: 00258
Shop #: WSC 00028
1 Fault Found:
00930 - Locking Module for Central Locking: Rear Left (F222)
27-10 - Implausible Signal - Intermittent
-------------------------------------------------------------------------------
Address 56: Radio
Controller: 1J0 035 186 D
Component: RADIO SON 0004
Coding: 01403
Shop #: WSC 00028
No fault code found.
End --------------------------------------------------------------------------------------------------
-
Clear all the codes and see what appears after that some can be old
-
I erased them, started the car and then scanned again here is the log
VAG-COM Version: Release 409.1-S
Chassis Type: 1J - VW G/J/B Mk4
Scan: 01,02,03,08,16,15,17,19,22,35,46,56
-------------------------------------------------------------------------------
Address 01: Engine
Controller: 06A 906 032 HJ
Component: 1.8L R4/5VT 0002
Coding: 11500
Shop #: WSC 00028
WVWZZZ1JZ2P049312 VWZ7Z0A4279546
1 Fault Found:
16486 - Mass Air Flow Sensor (G70): Signal too Low
P0102 - 35-00 - -
Readiness: 0110 1101
-------------------------------------------------------------------------------
Address 03: ABS Brakes
Controller: 1C0 907 379 K
Component: ASR FRONT MK60 0103
Coding: 0021505
Shop #: WSC 00028
1 Fault Found:
01314 - Engine Control Module
013 - Check DTC Memory
-------------------------------------------------------------------------------
Address 08: Auto HVAC
Controller: 3B2 907 044 C
Component: CLIMATRONIC C 2.0.0
Coding: 11000
Shop #: WSC 00028
No fault code found.
-------------------------------------------------------------------------------
Skipping Address 15-Airbags
-------------------------------------------------------------------------------
Address 17: Instruments
Controller: 1J0 920 926 A
Component: KOMBI+WEGFAHRSP VDO V06
Coding: 05412
Shop #: WSC 00000
WVWZZZ1JZ2P049312 VWZ7Z0A4279546
No fault code found.
-------------------------------------------------------------------------------
Address 19: CAN Gateway
Controller: 6N0 909 901
Component: Gateway K<->CAN 0001
Coding: 00006
Shop #: WSC 00028
No fault code found.
-------------------------------------------------------------------------------
Address 46: Central Conv.
Controller: 1C0 959 799 B
Component: 1X Komfortgerát HLO 0003
Coding: 00258
Shop #: WSC 00028
No fault code found.
-------------------------------------------------------------------------------
Address 56: Radio
Controller: 1J0 035 186 D
Component: RADIO SON 0004
Coding: 01403
Shop #: WSC 00028
No fault code found.
End --------------------------------------------------------------------------------------------------
-
16486/P0102/000258 - Mass Air Flow Sensor (MAF/G70): Signal too Low
Possible Symptoms
Malfunction Indicator Light (MIL) ON
Loss of Power
Possible Causes
Wiring and/or Connector(s) from/to Mass Air Flow Sensor (MAF/G70) faulty
Mass Air Flow Sensor (MAF/G70) faulty
Possible Solutions
Check Wiring and/or Connector(s) from/to Mass Air Flow Sensor (MAF/G70)
Check/Replace Mass Air Flow Sensor (MAF/G70)
----------------------------------------------------------------------------------
01314 - Engine Control Module: Check DTC Memory
Possible Causes
Fault(s) stored in Engine Control Module
Possible Solutions
Check Engine Control Module for Fault Codes
Special Notes
Engine Control Module stored a Code which influences other Control Modules Functionality.
To clear this Fault Code you will need to correct the Problem in the Engine Control Module first.
-
Thank you, how would i check the ECM in vagcom 409.1? i just cleared all error codes and rescanned.
Also, i found this hose had split.. not sure if it's anything to do with the MAF
(http://i670.photobucket.com/albums/vv67/mike19903/IMG00829-20120311-1258.jpg)
The ABS light doesn't light up on engine startup
-
i had exact same hose split too and it fooked my maf.. get silicone replacement off the bay mate :wink:
-
I will do mate, what are they called?
Also, how do i get to the engine control module in vagcom?
Is it the 01 - Engine controller? just i thought doing vagcoms Auto Scan would of picked up the codes for the ABS problem