GolfGTIforum.co.uk
Model specific boards => Golf mk2 => Topic started by: Dannyavw on 16 September 2011, 20:22
-
Hi I've fitted relay 30 in position 3 of fusebox On my mk2 vr6 conversion and my fuel pump is running all the time and I can't seem to get my indicator tell tales on mk3 dash pod to work, any suggestions cheers
-
Is the ECU good?
Fuel pumps running all the time when off is an indicator of blown ECU due to disconnected earth in some circumstances.
-
Sorry I'm not sure if I made myself clear enough the fuel pump runs all the time with relay 30 fitted with ignition on but constantly runs and if you turn ignition off it switches off. It primes but continues to run cheers
-
Sorry I'm not sure if I made myself clear enough the fuel pump runs all the time with relay 30 fitted with ignition on but constantly runs and if you turn ignition off it switches off. It primes but continues to run cheers
Is it definitely the correct relay? If it is, tried a replacement?
-
Swapped it from my mk3 gti and it does the same
-
Could be an ecu fault
-
Could be an ecu fault
As already posted - check the ECU in a known good car installation.
-
I would put money on the ecu. An earth isnt tight somewhere.
-
Check all earths continuity with a basic ohm meter
-
Im going with the wrong relay or the relay for the old digifant ecu is still in the fusebox.
As far as I am aware OBD ecu's from VR's dont suffer the same ground fault as the old digifant ecu's do.