GolfGTIforum.co.uk

Model specific boards => Golf mk2 => Topic started by: Craigwilson on 23 April 2011, 14:51

Title: Oil pressure ??
Post by: Craigwilson on 23 April 2011, 14:51

I fitted a 0-10 bar oil pressure sender to a gti 8v engine to operate the pressure vdo but it is always reading low pressure and when the revs drop below about 2000 the idiot light comes on. Could this be because i need a 0-5 bar sender instead of 0-10.

Title: Re: Oil pressure ??
Post by: 01664gti on 23 April 2011, 20:11

Have you tried fitting it into the oil cooler,With a t-piece??

I had a similar problem and that sorted it

Title: Re: Oil pressure ??
Post by: Craigwilson on 23 April 2011, 23:54

Will it fit in the space down there ? Ill giv it a try

Title: Re: Oil pressure ??
Post by: rubjonny on 27 April 2011, 10:31

check the ratings on the sender, it should have 1-10 bar and either 0.3 or 1.8bar stasmped on the flats. the 2nd reading tells you which sensor the vdo is supposed to replace. if it is the 0.3bar type then putting it in the head is fine, you just have a pressure problem to the head. i had the same with worn cam bearings

Title: Re: Oil pressure ??
Post by: Craigwilson on 09 May 2011, 00:24

Thanks if you say the cam bearing caused a pressure problem in the head ill check them coz they do seem very clicky.