GolfGTIforum.co.uk

Model specific boards => Golf mk4 => Topic started by: symsymma on 18 March 2011, 21:05

Title: forge i/c to throttle body hose
Post by: symsymma on 18 March 2011, 21:05

Fitted mine the other week and the bend nr throttle body on the internal radius side looks a bit pushed in is it the case that i need to shorten the hose slightly ie take a small trim of that end to make it right? Also the ic end on the external rad is touching the bodywork lip if u understand wot i mean.just wondered if anyone had had the same thing and wot they did about it.hope this all makes sense.thanks.

Title: Re: forge i/c to throttle body hose
Post by: symsymma on 19 March 2011, 18:34

Anyone? :huh:

Title: Re: forge i/c to throttle body hose
Post by: daz veedub on 19 March 2011, 18:38

my i/c to throttle pipe bends slightly mate but not much should be fine

Title: Re: forge i/c to throttle body hose
Post by: symsymma on 19 March 2011, 18:43

It doesnt look to bad maybe lost 5mm of the overall diameter.just wondered all the rest of them fit pukka. :laugh:

Title: Re: forge i/c to throttle body hose
Post by: vwfiend on 19 March 2011, 19:19

Have you tried twisting it slightly mate? The one with my Forge FMIC was rubbing on the back of the botyom of the headlight clip till i rearranged it. When its on boost itll puff out anyway mate  :smiley:

Title: Re: forge i/c to throttle body hose
Post by: symsymma on 19 March 2011, 19:34

Yea was thinkin mayb a twist and a fiddle mite sort it if ull pardon the pun. :smiley:not a major issue if i cant get it ne betta though? :grin: