GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: Armann on 17 December 2010, 21:40
-
Hello.
A 1998 Mk4 Gti Golf, have a 1.8T Skoda Octavia engine from 2004.
This is the engine, just wondering if it's going to be a problem putting it into the MK4 ?
If so then what ?
1.8 20vT Petrol 1,781 cc (1.781 L; 108.7 cu in) 4cyl DOHC 150 PS (110 kW; 148 hp) @5700 rpm 210 N·m (150 lb·ft) @1750–4600 rpm
-
Are you wanting to do the swap or has it already been done to the Golf...???? :grin: :grin:
Its not clear what you are trying to say / do......
-
would of thought it would have to be same code engine im not sure but just a guess :wink:
-
Sorry about not being clear :)
The engine in the VW is dead, and I have a 1.8T from a Skoda Octavia that's good.
Just wondering about the electronics or if there are any major problems since they are both VW 1.8T engines...
-
should be a straight swap mate..
-
the engine in the golf was an AGU and the other one is prob a AUM or AUQ.
I think the loom does not have all the connections but should not be a prob. i am sure some of the peeps here will tell you :)
-
Will not be a straight fit, you need both engine codes but I am sure the later one will need mods.
-
O.k I will post the codes when I get them...
-
Qctavia will be an AUQ.
-
^only if its a VRs, they did a lot of 150 "elegance" models too
you'll need the later loom and ecu if you want to run the skoda engine as it comes. Probably easier just to swap over the bottom end if that's what fubar'd
-
^only if its a VRs, they did a lot of 150 "elegance" models too
you'll need the later loom and ecu if you want to run the skoda engine as it comes. Probably easier just to swap over the bottom end if that's what fubar'd
You really are the 1.8T guru :laugh: