GolfGTIforum.co.uk

General => The garage => Diagnostics - VagCom / VCDS => Topic started by: Devilz on 18 July 2010, 19:33

Title: Fault code 00562 after fitting immo3 clocks
Post by: Devilz on 18 July 2010, 19:33: Just fitted some immo3 clocks to a car that had immo2. Anyway, after finishing installing them it had a warning on turning the ignition saying "'Oil Sensor - Workshop", this message wasnt on the immo2 clocks.

Anyway vcds came up with the below fault code which would not clear. I proceeded with the mte and lit needles, corrected the mileage then reset the VDO. This cleared the message "'Oil Sensor - Workshop" and i thought thats good and didnt do another scan.

Address 17: Instruments Labels:1J0-920-xx5-17.LBL

Part No:1J5 920 926 C

Component: KOMBI+WEGFAHRSP VDO V13

Coding: 01414

Shop #:WSC 00000

WVWZZZ1JZ2W617860 VWZ7Z0B4892532

1 Fault Found:

00562 -Sensor for Oil Level/Temperature (G266)

30-10 - Open or Short to Plus - Intermittent
Title: Re: Fault code 00562 after fitting immo3 clocks
Post by: Rhyso on 18 July 2010, 19:38: does the car have an oil level sensor? If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway
Title: Re: Fault code 00562 after fitting immo3 clocks
Post by: Devilz on 18 July 2010, 20:04: Quote from: Rhyso on 18 July 2010, 19:38
does the car have an oil level sensor? If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway

its W reg, agu. how will I know if it got one or not :undecided:
Title: Re: Fault code 00562 after fitting immo3 clocks
Post by: Rhyso on 19 July 2010, 08:01: Quote from: Devilz on 18 July 2010, 20:04
Quote from: Rhyso on 18 July 2010, 19:38
does the car have an oil level sensor? If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway

its W reg, agu. how will I know if it got one or not :undecided:

Look at the sump - at the very bottom you'll see a plug (not the sump plug) if its there
Title: Re: Fault code 00562 after fitting immo3 clocks
Post by: tshirt2k on 08 August 2010, 19:00: Doubt the car will have an oil sensor. You can get rid of i it i think by recoding the clocks to not use an oil sensor.