GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: will gti on 28 June 2010, 16:27
-
since installing my fk coilovers the abs light has come up on the dash can it be cleaned out or watever ... any help would be grreat :wink:
BOTH CABLES ON EITHER SIDE HAD BEEN RUBBING ON THE EDGE OF THE INNER RIM AND YESTERDAY MY DASH LIT UP LIKE A CRIMBO TREE CHECK BRAKE PADS ABS AND A ! FLASHING AND BEEPING SO TOOK WHEEL OF FOUND THAT THE SENSOR CABLES HAD BEEN MELTED NEARLY IN HALF FROM RUBBED BY THE WHEEL, :evil:
-
Code reader should be able to tell you exactly what it is and also clear it.
-
did you disconnect it? Might not have plugged it back in properly or just snagged a wire causing it to short out
-
didnt unplug it :undecided: didnt really touch it just unclipped it like from bracket
-
didnt unplug it :undecided: didnt really touch it just unclipped it like from bracket
probably a short in the wire mate
-
:smiley: so i wont need a new sensor then ? how do i sort that out then just clear code and reset light isit ?
just had the wheel off then nothing seems to be visably wrong like :undecided:
-
Had an abs sensor fault on mine when i changed the front/rear discs and pads did disconnect the brake pad wear sensor mine came up during a vag com scan had a look didn't find anything amiss cleared the code and didn't come back on :wink:
-
Check really carefully along the sensor cable...I damaged mine when fitting coilovers which caused the same warning light.
Will
-
nice 1 for the help had a look at the cable cant see anything but when went for a drive no light for about 20 mins untill i took a right hander at about 40 and then like magic the light came back on :undecided: :cry: :sad:
-
Try removing the 3 small fuses from on top of ur battery in the fuse holder and cleaning them and give the fuse holders a little blow, or use a small brush. I had a light on and this advice was given to me and worked. Worth a try :smiley:
-
nice 1 for the help had a look at the cable cant see anything but when went for a drive no light for about 20 mins untill i took a right hander at about 40 and then like magic the light came back on :undecided: :cry: :sad:
Sounds like a dodgy connection, maybe need to check a bit closer and wiggle them about to see what movement's in them.
-
do i need vag to turn the abs light of and the (!) light...... :rolleyes:
-
should clear itself after a few hundred yards as long as you've fixed the problem
The system does a self-test I believe :smiley:
-
sorted yeah hope i have lol aint been out for a drive yet tho i solderd and insulation taped both of them :rolleyes:
-
sorted yeah hope i have lol aint been out for a drive yet tho i solderd and insulation taped both of them :rolleyes:
take it for a spin around the block then to see if you've fixed it :tongue:
-
yeah will do when this stinker of a hangover pisses off :sick: