GolfGTIforum.co.uk
Model specific boards => Golf mk2 => Topic started by: retromk2craig on 22 February 2010, 18:08
-
this is a slightly awkward question to ask?? how dow you remove the front bumper?? on big bumper model. :embarassed:
-
There are 4x17mm bolts
Found this pic showing the 2 outer 17mm bolts:
(http://i205.photobucket.com/albums/bb197/Gloves88/IMGP2583.jpg)
-
where can i find thrm bolts? cheers
-
If you look under the car they are roughly inline with the front indicator and about a foot back from the front of the bumper
-
cheers guys?
-
These bolts also hold the front cross-member on so before removing those bolts be sure to support the cross member just underneath the front engine mount.
-
the inner 2 13mm bolts in that picture will hold the engine up if you take the bumper off, you can just see them hidden behind the white plastic clip in that picture. This assumes the bolts are still there and not stripped. so you dont have to support the crossmember when removing the bumper if those 2 bolts are in place.
however if you arnt 100% sure about the condition of them, supporting crossmember is a wise precaution to take
-
Is it still advisble to gently jack up the engine too the release the bumper?
-
no need, but if car is low might be hard to get to the bolts unless you jack it up a bit!
-
cheers guys all off,