GolfGTIforum.co.uk

General => The garage => Topic started by: braderz on 07 January 2010, 00:25

Title: brake bleed Q.
Post by: braderz on 07 January 2010, 00:25

began the gunsons eezibleed procedure earlier today as brakes are a bit spongy, got all setup, but i could not get the bleed nipple open on the right rear. The procedure says to start here so did not try any others. What can i do!? When i was doing this i left the handbrake off, does it need to be on, im going to try again with the wheel off but i wanna get it right before setting it all up again!

Title: Re: brake bleed Q.
Post by: roger1234 on 07 January 2010, 09:52

Put plenty of release fluid on the nipple and careful you don't snap it.  :smiley:

Title: Re: brake bleed Q.
Post by: oakgreengolf on 07 January 2010, 22:05

 Lots of penetrating fluid required, leave for a few hours to work. what car is it?. On some you have to clamp the bias valve open on the rear axle.

Title: Re: brake bleed Q.
Post by: AudiA8Quattro on 07 January 2010, 22:07

Don't use a spanner, try undoing it will a small 1/4 inch rachet and socket, you will be applying pressure more centrally.

Title: Re: brake bleed Q.
Post by: gazpowells on 10 January 2010, 16:42

Quote from: roger1234 on 07 January 2010, 09:52

Put plenty of release fluid on the nipple and careful you don't snap it.  :smiley:

+1

Title: Re: brake bleed Q.
Post by: braderz on 15 January 2010, 00:19

its a '99 gt tdi, whats a best fluid to use on that then? ive yet to try again as next time im taking wheel off for better access