GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: tomcat on 06 October 2009, 20:44
-
Hi all
Thinking of putting Ferrari 348 wheels on my mk3 but have no idea if they will fit, ideally I'd like a full set to have the 9" wide on the rear and the 7.5" on the front.
But would settle for 4 x 7.5" if that makes the difference between being able to do this or not. :undecided:
7.5" + 49mm offset - Front
9" + 68mm offset - Rear
Also the PCD is 5 108 and the centre bore is 67.
Cheers
Tom
-
Yes you could fit them with adaptors, 30mm rear and 20mm front, biggest problem will be finding the wheels plus the adaptors will need to be custom made.
-
would also need spigot rings for the centre bore
-
would also need spigot rings for the centre bore
Good point :smiley: unless the adaptors will do it.
-
Yes you could fit them with adaptors, 30mm rear and 20mm front, biggest problem will be finding the wheels plus the adaptors will need to be custom made.
Thanks peeps
I found some 5x100 to 5x108 adapters on american ebay. they say they are 1.5 inches thick, sounds a bit too much to me but is that ok for space.
Also the 20mm and 30mm measurements you give, are they for the 9 inch wide wheels on the back or the 7.5 inch?
Don't want to search for months and make a very expensive mistake.
Thanks
Tom :smiley:
-
Yes you could fit them with adaptors, 30mm rear and 20mm front, biggest problem will be finding the wheels plus the adaptors will need to be custom made.
Thanks peeps
I found some 5x100 to 5x108 adapters on american ebay. they say they are 1.5 inches thick, sounds a bit too much to me but is that ok for space.
Also the 20mm and 30mm measurements you give, are they for the 9 inch wide wheels on the back or the 7.5 inch?
Don't want to search for months and make a very expensive mistake.
Thanks
Tom :smiley:
That was based on 9" rears, 7.5 all round might be better for clearance.