GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: Amzy-Bear on 14 July 2009, 15:31
-
My Starter motor is f**cked. I Have the replacement in the boot.
Are they hard to fit ? because i have a couple hours spare !!
Is there and tricky bits, or is it a case of just swapping them over ?
Thanks in advance
-
They look a pack of piss to replace, its easly accessible.
Haynes rate it 3 spanners - reading it it dosn't seam too hard either.
-
Should be easy enough to change.
-
Okay guys, ill have a read through it now and see how i do lol
-
Disconnect the battery! I have a melted spanner somewhere
due to changing the starter on my old XR4i :grin:
-
Gona say, Iv seen a live feed weld a screwdriver to the bodywork. Was abit shocked when I seen it :tongue:
-
Gona say, Iv seen a live feed weld a screwdriver to the bodywork. Was abit shocked when I seen it :tongue:
Even more shocked when it burns your feckin hand, still i have two :laugh:
-
He He leave the battery connected and you can change the starter and do some welding at the same time. :laugh:
-
i just had a go, but i havent got the right tools lol i got some crappy tool set from halfords.
And i need a ratchet to do the job, a 16mm. but it wont go on because of the piece that the nut screws onto is to long.
need to find some more tools lol
And i forgot to disconnect the battery lol but im still alive
-
Any sparks?
-
no none at all, disconnected all the wires that go into the starter motor and that was fine.
its just the bolts were in funny places, and because i didnt have the right ratchet i had to use a spanner, and the pipes that go into the thermostat were in the way !!
so i had to put it back together because it wouldnt work and it started raining :(