Today i got busy making a custom cold air feed using the shell of a fog lamp, as neither of the fogs are wired in anyway.
The fog lamp:
Taking the projector out of the front casing:
Prised the tabs off to remove the projector lens:
Scraped the sealant off the projector back, to prise open tabs retaining the lens holder in place:
Cut the back off the projector shell:
Trial fit of 50mm cold air feed. Will extend to around double this length. It didnt hold with a jubilee clip as the projector shell is tapered, so superglue came into play:
Smashed the glass off the fog lamp front to reveal inner shell:
Painted projector shell and fog lamp front:
Clipped back together:
Installed:
The extendible CAI will run up through the chassis leg and into your aribox/cone filter