Stock Performance Pack disc and pads

[jh_97]

Yes exactly, that's why I'm curious why the sensor hasn't flagged anything if they really are that low.

Interestingly, I double checked my invoice from the check... It says front brake pads on arrival were 5mm, but then at the bottom they need renewing as they're 1.6-3mm left... Perhaps this is why the sensor hasn't triggered anything  They did also state that the tyres I've had on for less than 1000 miles are all 50% worn as well...

Happy to be cautious and change them anyway, just interested about the sensor

[jh_97]

Just bumping this up again in the hope someone knows the answer..!

What remaining thickness do the brake pad wear sensors trigger?

[Agreeable Slick]

Depends on how well the wires are seated.

Nominal is usually around 2-3mm, but they can be higher or lower. It should create a short when you remove enough friction material to expose the wire and wear that down.

[jh_97]

Thanks!