Next remove the heater controls and place them on their side for easy access - donÂ’t unplug it though!
ok now pull the gear lever surround upwards
then undo the 2 screws holding the ashtray in place
Then place your remote button from the control unit where you would like it and feed the wires beneath the ashtray and retrieve them at the rear of the air con control unit.
then replace the ashtray, screw the screws back in & replace the gear stick surround
MAKING CONNECTIONS
Ok next we take the RADIO (FEMALE) end of the adapter lead and insert the plugs that we removed from the radio loom
then insert the RADIO end of the adapter into the radio
next plug the cars radio loom into the adapters other (male) plug
then push the wiring loom into the dash, out of the way but leave the CAR KIT wiring hanging out.
next feed all remaining car phone wiring through to the rear of the radio bracket and out of the air con bracket
FEEDING THE MIC WIRE THROUGH
The next phase is to feed the mic wire from the cubby to the air - con bracket area - tape the 2 highlighted wires together
and feed the wires behind the dash up to the rear of the heater controls
MAKING FINAL CONNECTIONS
ok now simply plug all your connectors into the CAR KIT CONTROL UNIT
then fix the unit at the rear of the heater controls using Velcro etc - then push the radio back into place
There should be 1 wire left waving around - the blue one you cut off the loom at the beginning - this provides the car kit with the switched ignition supply that it needs - strip around 1cm of the insulation off.
then join it to pin 20 of the heater controls - a black wire with a blue tracer - if this is not present then find an ignition live using a multi meter.
the unit is now functional - pair up your bluetooth phone and test it!
when using your phone the radio will now show phone or telephone, mute your radio and the speech from your call will be played through your front speakers!
REASEBLE THE CAR!ÂÂÂ