Just opened my VAg com cable that i recently purchased off ebay and installed the software and then ran the program after setting up the ports as instructed by the read me file, everything seemed to be going fine up until i proced with the auto scan then. I choce mk4 g/b/j from the list and then as it starts trying for address the window fades to a funny white colour which disables any futher use and then appears a smaller window say "VAG-COM has stopped working" any idears?
I run the test and it says:
port status:ok
Interface:found!
type serial pass- through
opto/iso:no
Ross- tech design: no
port slected is Com4
first couple of times it ran through it fine up till when it started to give me the fault codes then it stops working .