Checked the oil, topped up screenwash & checked brake fluid level, no top up needed.
Changed the front discs, took the calipers off & gave them a good clean with a wire brush & greased them right up & slapped new pads in
The new one's had no brake wear sensor but the original one's did but they were not connected up (no light on in dash but is present) & i could not see/find where they would plug into? Just a wire for the abs sensor unless i am going blind?
I have the ATE system on my anni, ECP stock's Lucas & ATE caliper's when i put my reg number in, so i never ordered one but i saved myself some coin by just cleaning & greasing the original caliper
Attempted to fit another set of locking wheel nuts but the thread was too small, so will be sending them back!
rear discs, pad's & brake fluid change on the to-do list as it started to rain
*I had a little help from a friend to do the above, I am learning
*