Fault code 00562 after fitting immo3 clocks

[Devilz]

Just fitted some immo3 clocks to a car that had immo2. Anyway, after finishing installing them it had a warning on turning the ignition saying "'Oil Sensor - Workshop", this message wasnt on the immo2 clocks.

Anyway vcds came up with the below fault code which would not clear. I proceeded with the mte and lit needles, corrected the mileage then reset the VDO. This cleared the message "'Oil Sensor - Workshop" and i thought thats good and didnt do another scan.


 
Address 17: Instruments      Labels:1J0-920-xx5-17.LBL

 

Part No:1J5 920 926 C

Component: KOMBI+WEGFAHRSP VDO V13

Coding: 01414

Shop #:WSC 00000

WVWZZZ1JZ2W617860     VWZ7Z0B4892532

1 Fault Found:

00562 -Sensor for Oil Level/Temperature (G266)

           30-10 - Open or Short to Plus - Intermittent

[Rhyso]

does the car have an oil level sensor?  If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway

[Devilz]

does the car have an oil level sensor?  If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway

its W reg, agu. how will I know if it got one or not 

[Rhyso]

does the car have an oil level sensor?  If not then it will always come up as a code as its looking for something that isn't there

You can code that out anyway

its W reg, agu. how will I know if it got one or not 

Look at the sump - at the very bottom you'll see a plug (not the sump plug) if its there

[tshirt2k]

Doubt the car will have an oil sensor. You can get rid of i it i think by recoding the clocks to not use an oil sensor.