engine light

[Bazza]

Car looks sweet dude. I had one of those tuning boxes on my previous golf and it went like stink. So definately doing it again. Don't forget to inform your insurance when you do it.

[STEVETDI]

thanks and yeah right

[STEVETDI]

thanks let see if it works

[Bazza]

Cool

Lol. You can make it a little smaller but not quite sure how you do it.

[Bazza]

First thing to get is one of these, miles better than the c**p paper one's 

Plus don't ever need replacing, just cleaned.  Swear by mine, engine breathes better.

http://cgi.ebay.co.uk/K-N-Air-Filter-VW-GOLF-MK3-1-4-1-6-1-8-1-9D-2-0-VR6_W0QQitemZ260042110484QQihZ016QQcategoryZ9889QQssPageNameZWD1VQQrdZ1QQcmdZViewItem

[STEVETDI]

looks like it's got one as there is a K&N ifo sticker in the engie bay not double checked.

btw do you know what "inos" means it shows up in te display?

[Bazza]

Yeah seen that too, my theory is the same with the light's. If it goes out, don't worry about it 

[STEVETDI]

after typing in02 in to the search on the mk3 site I found out it's a service light there is a trick to cancel it , I have pasted it below I will give it a try and let you know how I get on.

OEL= oil service
Switch ign on
Press and hold l/h button on dash
Switch ign off
Release button
The letters "OEL" will appear on the speedo display
Pres clock minute button until "-----" is shown
Switch ign on and "IN00" should show

IN01= inspection service
Ign on
Press and hold l/h button on dash
Switch ign off
Release button
Press and release button
IN01 will show in the display
Pres clock minute button until "-----" is shown
Press l/h button to show "OEL"
Press r/h button to show "-----"
Switch ign on and "IN00" should show

Press and hold l/h button on dash
Switch ign off
Release button
Press and release button
IN02 will show in the display
Pres clock minute button until "-----" is shown
Press l/h button to show "IN01"
Press r/h button to show "-----"
Repeat to reset "OEL"
Switch ign on and "IN00" should show

[Bazza]

Would appreciate feedback about this 

Saw INsomething came up, not sure what number it was. Will check it later, thanks again for info.

[richandhazel]

No worries dude 

The mk2 and mk3 area's haven't got a Tdi section for some reason  , only picked up your thread by accident.

Thats my fault. Good point. Not sure that we need a mk2 section but a mk3 TDI section might be a good idea. Just wondering whether to have a 'stand alone' TDI section that covers all mk's or whether to have a child board within mk3 same as I have done with mk4