GolfGTIforum.co.uk
Model specific boards => Golf mk4 => Topic started by: markgti1.8t on 25 September 2013, 20:18
-
can any one tell me what nozzle they are using on there wmi as i think they have send me the wrong nozzle as its feels like its putting to much meth/water in as when it squirts in feels hesitant and not as much power as when i disconnect the wmi thanks mark
-
what jet do you have? I've got two lol
-
what jet do you have? I've got two lol
they gave me a number 3 and 7 using the number 3 the now but think it would be better with a number 2
-
what's your start point for injection?
I use the medium AEM nozzle on mine, starts injecting at 10psi, ramping up to full injection at 20psi
-
Me? Not sure if so lol
-
my cars not mapped yet starts at 6psi
-
25% of injected fuel quantity for me
-
has anyone got this problem
-
I'd say starting at 6psi is too early mate...
-
can wmi be used on stranded map
-
can wmi be used on stranded map
why not just get yours mapped :smiley:
-
need to get the turbo first want a k300 but think im just going to stick a k03s in the now soon as i find a good one
-
need to get the turbo first want a k300 but think im just going to stick a k03s in the now soon as i find a good one
plenty of them about cheap :smiley: not sure they would be any good though and if you have to factor in rebuild cost better just buying new hybrid
-
OP: What psi did you set as full flow/max boost?
-
starts at 6psi boosting up 2 12psi
-
As it's still standard, it might be too much to have full flow by 12psi, try setting the max flow for 20psi
-
Whats your max psi, where mounted nozzles and nozzles flow rates if know them. I run 270cc aquamist nozzle after fmic and run direct port and have 25cc nozzles in intake runners. Wmi start 15psi 100% at 25psi my max psi is 30. Need check timing pull with vagcom use that set wmi start. Id start wmi at half of your max psi and 100% couple psi before max psi and check timing pull and adj wmi start accordingly. Set up correctly its awesome takes time.
-
His engine is running standard map.
-
What max psi on standard map?? Say standard map 10psi 150hp your nozzle will be pretty small around 150ml/min.