« Reply #88 on: 23 April 2011, 19:52 »
went to install my homade catch can today, but was getting confused with the sump breather...
i think its the one near the dipstick with two 90degree bends on the tube, one end going to the engine and the other to a t-piece???
removed the t piece, and was going to just straight connect the two reaining, but couldn't get my tube over them.
i was the going to use the t piece for the install (if that makes sense?)
am i going along the right lines here?nr the dipstick u got the big elbowand a smaller hose blank off smaller one and connect to the big elbow.u remove the t piece and valve etc if im makin sense mate
Logged
1.8T AGU 203bhp & 233lb/ft Rtech stage 1 custom remap,18"dezentz rims,lowered 40mm shocks n springs,whiteline 24mm adj rear arb,lcr axle bushes,polybushed arb,modified front bumper & valences,depo projector headlights,delocked,wrapped interior&bora gear knob,forge boost & coolant hoses,forge tip,forge 007p,samco vac hoses,simota aeroform cai,saiko michi catch can,deleted pcv system,r32 dogbone,miltek lg bore down pipe & sports cat/non res anni style system.