Author Topic: Pulling away very lumpy at low revs ?  (Read 3343 times)

Offline Golfgtimk3

  • Just got here
  • *
  • Posts: 4
Pulling away very lumpy at low revs ?
« on: 04 May 2017, 16:59 »
Hello when slightly using the excellerator the car judders vigerasly if you give it a lot of gas it's ok !
I've had the distributor , fuel filter, plugs and cables , crankshaft sensor and coil pack replaced but still doing this ! I can't seem to find an answer 1min car was fine an then this happened .
Please can someone help .
I hope I've described the problem right .

Offline Golfgtimk3

  • Just got here
  • *
  • Posts: 4
Re: Pulling away very lumpy at low revs ?
« Reply #1 on: 04 May 2017, 17:02 »
Btw it's a mk3 golf gti 8v .

Offline lemski

  • Forum addict
  • *
  • Posts: 4,017
  • 16v
Re: Pulling away very lumpy at low revs ?
« Reply #2 on: 05 May 2017, 07:48 »
Throttle position sensor.
Has it been scanned

Offline itavaltalainen

  • I live here
  • *****
  • Posts: 2,689
  • VCDS and VCP - fault codes, coding, VIM activation
Re: Pulling away very lumpy at low revs ?
« Reply #3 on: 05 May 2017, 08:18 »
2E, ADY or AGG?
2019 Seat Leon ST FR DSG 135kW - eclipse orange - 23k miles

Offline Golfgtimk3

  • Just got here
  • *
  • Posts: 4
Re: Pulling away very lumpy at low revs ?
« Reply #4 on: 05 May 2017, 19:24 »
It's AGG

Offline Golfgtimk3

  • Just got here
  • *
  • Posts: 4
Re: Pulling away very lumpy at low revs ?
« Reply #5 on: 05 May 2017, 19:31 »
It hasn't been scanned, a cowboy garage  told me to disconnect battery an reset ecu so did that an made no difference . But will that mean all codes all gone ? 
Iv not got much knowledge on cars btw .
When pulling away or at these low revs when the throttle is only slightly down the car really jerks around . It's really difficult to drive . "Just trying to explain what is happening .."

Offline gasketface

  • I live here
  • *****
  • Posts: 1,236
Re: Pulling away very lumpy at low revs ?
« Reply #6 on: 05 May 2017, 20:49 »
engine mount gone ????

Offline itavaltalainen

  • I live here
  • *****
  • Posts: 2,689
  • VCDS and VCP - fault codes, coding, VIM activation
Re: Pulling away very lumpy at low revs ?
« Reply #7 on: 07 May 2017, 17:38 »
TB potentiometer?

Scan for faults and measuring blocks too. I can do scan if you're near me.
2019 Seat Leon ST FR DSG 135kW - eclipse orange - 23k miles