i came down monday, to get a rolling road on my audi a3 1.8t, i came with my friend dez from milton keynes. i had all the bits installed for stage two remap, i was going to leave the remap and wait a few months for the hybrid route. we spoke and decided stage 2 was the route to go first, what i thinks a good idea. Making sure the car is running right.
i got 208bhp on the rollers, and said it was about 20bhp under what it should be and 30 pound of torque under. Tomorrow i will be changing the baileys resurclation valve to the forge 007p, and changing the rubber washers on the injectors because they where leaking a bit, and slightly changing the oil catch can install.
if i come down to r-tec again, i think you said come down for the stage 2, when doing this, will you have a deeper look and see if you can underline why its not pushing the slightly higher bhp n torque figures? before the stage 2 is installed? also is there anything else i should clean out or change before i come down for my next visit.
thanks andy