GolfGTIforum.co.uk
Model specific boards => Golf mk5 => Golf mk5 how to guides + info => Topic started by: The Doc on 20 May 2006, 17:59
-
How to fit a MK5 GOLF Nokia Car Kit and get your radio to mute, and get your sounds through the car stereo speakers.
ok here goes....
To do this job you will need:
An autoleads interface lead ( 06-116b VW 2003- ) and car phone kit - the one shown here is the Nokia Advanced Hands free Bluetooth Car Kit CK-7W.......
(http://img210.imageshack.us/img210/1111/dsc030211wb.jpg)
1= Interface, 2= Microphone, 3= Control Unit and remote
Some insulating tape, wire strippers & cutters, torx T20 and T15 drivers and a small flat screwdriver or pick set.
(http://img57.imageshack.us/img57/1779/dsc030171uj.jpg)
and about 1.5 hours......
PREPARING THE LOOM
Unpackage the loom and find the RADIO (Female) end and look for the BLUE wire that goes to the CAR KIT CONTROL UNIT.
(http://img208.imageshack.us/img208/8638/dsc030181mz.jpg)
Once found, Cut this wire at the RADIO end and pull it out from its loom.
(http://img57.imageshack.us/img57/6351/dsc030194uq.jpg)
Tape up the loose wire on the RADIO end of the plug.
(http://img208.imageshack.us/img208/2592/dsc030206wy.jpg)
FITTING THE MIC
Remove the fuse box cover on the end of the dash
(http://img465.imageshack.us/img465/1381/dsc030227lx.jpg)
Then remove the plastic bar shown below by pulling on it
(http://img208.imageshack.us/img208/3459/dsc030236xr.jpg)
Next open the cubby below the main light switch
(http://img208.imageshack.us/img208/7826/dsc030250dx.jpg)
Remove this by squeezing the sides as show. Pull the box down and outwards.
(http://img208.imageshack.us/img208/7322/dsc030270hi.jpg)
(http://img206.imageshack.us/img206/1549/dsc030284dd.jpg)
Next, hold your mic at the top of the A pillar and run the wire from it behind the A pillar trim as shown AND ONLY THIS WAY SO AS TO AVOID PROBLEMS WITH SIDE AIR BAGS PLEASE :wink:
(http://img206.imageshack.us/img206/8284/dsc030295bw.jpg)
(http://img61.imageshack.us/img61/7573/dsc030302ka.jpg)
Then run the wire to the bottom of the a pillar trim - hide the wire by pulling the rubber back and inserting the mic wire.
(http://img66.imageshack.us/img66/7366/dsc030310el.jpg)
(http://img216.imageshack.us/img216/2208/dsc030325iq.jpg)
(http://img293.imageshack.us/img293/5972/dsc030332bg.jpg)
At the bottom of the a pillar trim insert the plug end of the mic through the hole as indicated
(http://img205.imageshack.us/img205/3446/dsc030345ck.jpg)
Then pull it out through the cubbyhole opening. Leave the mic wire there for now.
REMOVING THE RADIO CONSOLE
Look to the top of the console at the air vent ( NOT on non-climate cars simply remove rubber mat and follow below )
(http://img293.imageshack.us/img293/5200/dsc030381jy.jpg)
Remove the small light sensor at the rear of this vent and unplug it.
(http://img66.imageshack.us/img66/5337/dsc030391om.jpg)
(http://img293.imageshack.us/img293/9117/dsc030409ag.jpg)
Then insert your fingers into this hole and pull upwards to remove.
(http://img210.imageshack.us/img210/1401/dsc030414wl.jpg)
Once this vent cover has been removed look to the rear to find a screw - remove this.
(http://img210.imageshack.us/img210/412/dsc030437tg.jpg)
Then insert your fingers into this panel hole and pull upwards to remove.
(http://img293.imageshack.us/img293/1094/dsc030446sx.jpg)
Look into the top and you will see 2 more screws, Remove these.
(http://img210.imageshack.us/img210/3540/dsc030464iw.jpg)
Then pull the upper radio/air vents panel upwards to remove it - this is a little painful!
(http://img79.imageshack.us/img79/3923/dsc030475cz.jpg)
Next remove the 2 screws shown
(http://img210.imageshack.us/img210/8182/dsc030488kp.jpg)
Then remove the facia panel by pulling it towards the rear of the car, from the top corners.
(http://img210.imageshack.us/img210/8673/dsc030499kp.jpg)
(http://img210.imageshack.us/img210/771/dsc030507hq.jpg)
(http://img210.imageshack.us/img210/8310/dsc030516is.jpg)
(http://img216.imageshack.us/img216/2454/dsc030520vs.jpg)
(http://img210.imageshack.us/img210/259/dsc030538pz.jpg)
Once the front panel is removed there are 8 screws holding the radio and heater controls in place - remove these
(http://img79.imageshack.us/img79/259/dsc030544ij.jpg)
Now slide the radio out and place it on top of the dash.
(http://img221.imageshack.us/img221/5788/dsc030558wb.jpg)
Unplug the main loom by pressing the fastener together and pulling backwards
(http://img231.imageshack.us/img231/7852/dsc030569lw.jpg)
If you have a cd changer or sound pack etc now it the time to remove the extra plugs from the loom. DO NOT TRY TO REMOVE THE 2 MAIN WIRING BLOCKS only the "clipped" in ones.
(http://img231.imageshack.us/img231/8159/dsc030583xh.jpg)
:grin: :grin: :grin: :grin: :grin: :grin: HAVE RUN OUT OF SPACE - SEE PART 2 :grin: :grin: :grin: :grin: :grin:
Linky to part 2: http://www.golfgtiforum.co.uk/index.php?topic=40936.0
-
Mod thanks for making this sticky! :grin:
-
Good work Doc.......... I'd have to use some tape on the screw tips though!!!! :cool: :cool: :cool:
-
OK great idea but if your carefull (like I am) you won't need it :grin:
-
OK great idea but if your carefull (like I am) you won't need it - plus this is my job so I'm used to doing it! :grin:
LOL, i have many screwdriver and spanner scars from similar jobs :shocked:
-
Well in future you know who to ask to avoid such irritations to your cars skin :grin:
-
hey Doc
Morning!! just going thru your install pix - got me a dvd sat nav on ebay and need to hook it up.... notice you have one.... so are you able to say whereabouts the gps aerial is sited? Or is yours factory fitted on the roof as part of the aerial. For those of us doing it as a retro fit any pointers where we should site it?
thanx in advance
-
on the dash would do wouldn't it? Basically it needs to see the sky!
-
Sorry for the delay - YOu can put it behind the dash - yes BUT make sure there is no metal in the part above your ariel!
You could also put it in the top mounted air vent if you have on as this is made of plastic :wink:
-
thanx doc
at the moment it is just sitting on the dash - will need more time to locate position under dash nearest to the front. but yep it was really plug and play - impressed! and now my gti is almost there ....te he he. looking into the phat noise system but this means no cd's :cry:
any how next on my list is your nokia bluetooth setup and hooking up my active sub....
thanks man
-
:smiley:
-
Just an update
Now got sub, and cd/mp3 changer runnin. I was one of those numpties who didnt order highline with MFSW cos i was planning to have a different unit put in. :angry:
But looking into a mod for this - so soon will have the buttons to control the stereo! more airbag territory!
cheers
-
Be carefull with that one - I bought an MF leather wheel to fit to my Caddy but there was no wiring comming from the car to plug into the wheel :sad: so I have have had to make do with a non MF wheel :sad:
My missus GT TDi did not have the wiring either :sad:
If you crack this one let me know!
-
hi Doc
i have cracked it - in theory - got help from other vw forum guys!
Your right - MFSW doesnt come with the connectors from the switch modules to the steering column plug. What is need is a new airbag loom - so you can use your current airbag.
This loom has three connection points. From steering column to airbag. And then on from air bag to modules. part num 1K0 971 584 C cost approx £30
So one needs this loom plus a MFSW minimum. I understand that depending on your cars build, programming of/and/or new can bus may also be needed. - mines apr 06 build so may be ok. But i will start with the first two as they are mos def needed. then work from there
will u posted
-
Nice work - I stopped as it was not that critical for me in my Van :wink:
Go get 'em tiger!
nice job nice job nice job
-
Any luck tom?
-
.... :cry:
-
............. :sad:
-
Hi Doc.
just joined this forum and hoping you can help.
We've just collected our brand new Tornado MK5 GTi - great car. I'm looking to fit the Nokia wireless kit shown in this thread (very very useful info BTW). However, Doc you say:
"An autoleads interface lead ( 06-116b VW 2003- ) and car phone kit - the one shown here is the Nokia Advanced Hands free Bluetooth Car Kit CK-7W......."
We have an RCD 500 with the 10 speakers. On this website they say we need a different adapter (A BMW shaped one):
http://www.siocommunications.co.uk/06-076B.html
http://www.siocommunications.co.uk/06-116B.html
Is this wrong?
Thanks for any help you can give before I buy the bits.
T/.
:huh:
-
Very sorry for the delay m8!
Did you win or do still need help?
-
I've not got around to doing this yet - will probably be in the new year now. Would still like to know which part to get - I'll probably get the 'original' part unless anyone knows that the RCD500 really does require the BMW shaped one.
Any light you can shine on this would be appreciated to save me having the car in bits for a few days while I return/get sent the right adapter cable.
-
This one mate! http://www.siocommunications.co.uk/06-076B.html
-
Thanks - interestingly, since I posted my original request they've updated the website to say RCD 300 and RCD 500 ... just said RCD 300 before with the other one being RCD500 and BMW.
-
Hi I have been on the web looking for the best price for the telemute interface lead for a gti mk5 with 10 speaker set up and they recommend the 06 116b. Can I controll the phone from my steering wheel controlls as well?
cheers
chris
P.s whichever is right who's selling the cheapest (quality lead)
-
NO mate, the wheel only controls the volume. :wink:
-
hi i bought the nokia kit can anyone reccomend an installer in Cumbria ?
-
Great advice!!! i will use your method to install my VW i-Pod adapter
I dont suppose you would be able to advise me on how to wire in my Road Angel as i currently
have it plugged into the ciggarette socket and it spoils the look. Cheers!
-
You can take power from the rear of the dash fuse box on the drivers side or wire it into the phone connections.
When your fitting the kit call me - you will find my number on my web. and I'll tell you how to wire in your radar detector.
-
just had a ck7-w fitted by ice station in bury st edmunds (suffolk) took about half an hour sorry guys dont know how much they would charge as the owner is a mate and didnt charge me
-
Cheers Doc
I managed to wire in my VW i-Pod adapter no probs apart from getting the brown wire out of the
block as you need a special tool, but a safety pin sufficed, Your Nokia instructions helped no end
Thanks!
I will give you a call when im gonna install my Road Angel...... I think i'l need it the way that 2.0T goes!!! :laugh:
-
Hi Doc
Just thought i'd let you know i managed to wire in my road angel ok, the Black and Green wire
was a switched live so that worked a treat, now i have no messy wires in the way!
many Thanks!
Snips! :grin:
-
The Doc, at the end of your post PART 1 you say " HAVE RUN OUT OF SPACE - SEE PART 2 "
I can't figure out how to get to PART 2?
Can you help please.
pswinbank
-
http://www.golfgtiforum.co.uk/index.php?topic=40936.0 :wink:
-
The Doc, Brilliant. Many thanks for responding so quickly.
You don't by any chance happen to live in or around North Yorkshire do you?
pswinbank
-
Merseyside matey :wink: