wiring again

[crazydog]

hi guys,i have taken a feed wire from the ignition stud on the relay panel,i need to get this single wire through to under bonnet side,i have searched for somewhere i could get it through,, no success,any ideas without taking to many panels off,alternatively is there an ignition fed source under the bonnet i could tap into. all ideas welcome,if neccesary even drilling hole somewhere.  cheers.

[lemski]

Where the actual engine loom comes through driversside in the scuttle theres a panel. Its also pretty close to the fuse box

[crazydog]

sorry mate searched all in that area drivers side can't see any panel or even the main loom.  cheers

[crazydog]

is it behind the relays

[lemski]

It is but you need to take the plastic scuttle out to see where the loom goes into

[crazydog]

ok thanks i'll have another go at that tomorrow,it gives me more idea where to look  cheers

[crazydog]

thanks for info finally got it sorted as re your advice. one thing this will sound stupid, but when i came to put the scittle back all was ok until last bit which was two small pieces of plastic trim one each end of scuttle,no prob when i got them out but i can't figure how they go back i've tried all ways and they dn't fit right nowhere near  cheers.

[lemski]

Without seeing a picture i wouldnt know. Ive fitted loads back in but cant remember exactly what went where

[bgbazz]

Any chance those bit should have gone in first, before the scuttle itself? My car is away at the moment or I would check for you.

[crazydog]

they must go in last as i took them out first before removing scuttle,just had another go still no luck,if i can see any one else outside i'll have a look at theirs cheers