ABD cooler was going to take too much work to make fit so it's been sold again and a THS intercooler bought to replace it
it needs a small bit of modifying to fit so I took the crash bar off and drilled the spot welds out to enable a metal plate to be removed
The metal that needs removing
and out after a bit of beating with a hammer and chisel
the intercooler hanger bolted on
Will get a pic of it on the car as it is now in a bit. I've used Dave's spare bumper as mine needs trimming and I haven't had the time yet
I've got hold of a spare airbox lid thanks to daz_veedub so that can be modified to accept the VR6 MAF housing so I won't lose the use of my current one. I should also have a manual boost controller here soon to help with the next stage of tuning.
I've also decided to fit a set of oil temp/pressure gauges just to monitor what's going on. I've bought a dual pod for the A pillar and will be using these gauges
http://www.ebay.co.uk/itm/230678615498?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649the pod will be trimmed in the same material as I used to cover the headlining
http://www.ebay.co.uk/itm/150687402297?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649Wayne has kindly supplied me with everything I need to get the gauges plumbed in so this should be happening as soon as the gauges are here and I trim up the pod